Sonic soot blowing refers to the method of removing the ash of the heated area of the boiler by the action of the sound field energy, which is completely different from other cleaning techniques. Acoustic soot blower technology is to convert compressed air (or steam) into high-power sound waves (a pressure wave propagating in a space medium (gas) in the form of sparse waves) into the furnace, when the product on the heated surface When the ash is repeatedly pulled and pressed by alternating waves with a certain frequency, it will fall off due to fatigue, take away with the smoke flow, or fall to the ash discharge under the action of gravity. During the production and operation of the boiler, the surface ash and slagging of the heating surface—water wall, superheater, economizer, preheater and flue—is a problem that has long been plagued by production and difficult to solve. It not only reduces the heat transfer of the heating surface of the boiler, but also reduces the thermal efficiency of the boiler and reduces the production load. Moreover, when the ash and slagging in the heated area are serious, it may cause accidental shutdown and cause major economic losses. At present, most boilers are equipped with steam soot blowers, compressed air soot blowers, steel ball soot blowers, etc., but these traditional soot blowers have limited range of soot blowing, dead ends of soot blowing, and energy The disadvantages of high consumption, large maintenance cost, inconvenient operation, side effects, etc., the usage rate is very low, and most of them are not used. Therefore, new technologies must be sought to remove the ash from the heated area of the boiler and prevent slagging. In the 1970s, the Swedes first discovered and used low-frequency sonic cleaning technology for boilers, which opened up a new way for boiler cleaning, and has been widely used and achieved good results.
Characteristics of sonic soot blowers
First, the structure is simple, the body of the soot blower does not need electricity, there is no mechanical motion rotating mechanism, there is no wearing parts, and there is no mechanical motion rotation failure.
Second, small size, light weight, no telescopic mechanism, no mechanical jamming phenomenon. Third, the material is resistant to high temperature, wear, corrosion, aging and long service life.
Fourth, it is safe and reliable, will not be thinned or blown out of the tube bundle, and will not cause the phenomenon of tube bursting, and meet the requirements of personal safety and industrial labor protection regulations.
Fifth, the sound wave performance is high, the power is large, the frequency bandwidth, and the cleaning effect is remarkable.
Sixth, a wide range of adaptation, can be applied to any furnace type and any part of the boiler, including furnace water wall, superheater, reheater, economizer, air preheater, electrostatic precipitator, etc.
7. The gas consumption is small, the power consumption is small, the gas source medium is optional, and air or steam can be used. Eight, the installation range is wide, in addition to the need to open another hole in the furnace wall, you can use the original soot blower hole, coke hole, fire hole and other locations for installation.
Nine, easy to install, do not need to set up a soot blower platform, the space inside and outside the furnace wall is small, does not affect the boiler maintenance work.
X. The control system is divided into automatic and manual functions, which can be self-contained or connected to the DCS system to achieve full automation.
