The Effect Of The Steam Blowing Ash Machine And Its Effect On The Operation Of The Pottery Furnace.

Apr 23, 2024

Leave a message

The pottery oven has been running for a long time, the heating surface is heated and the raw ash and charcoal are heated. Due to the long history of fuel production, a number of re-burning accidents occurred, and the operation of the pottery furnace took a while. After that, the heating surface is blown away and the heating surface is clean. The ash blower has one type of short ash pipe with a water-cooled wall and heating surface, and one type of ash blower has one type of ash pipe with a long heating surface.

 

Effects of blowing ash on the operation of the pottery furnace: The blowing ash effect of the blowing ash pottery furnace is different, the blowing ash effects are different, and the number of details during the ash-blowing process is small. The blowing ash burns a certain effect.

 

During the process of blowing ash, the ash is heated, the ash is heated, and the ash is burnt at a low cost. Increasing capacity, then decreasing temperature. Due to the fact that the blasting of ash was caused by the blowing of ash, the damage caused by the blowing of ash during the period of the blowing of the ash was large enough to prevent the blowing of ash. During the operation of blowing ash, the blowing ash ware was installed. As a result, if the ash-blowing device is in the furnace and there is no leakage, the ash-blowing device will stop immediately and the timing.

 

Pot furnace, heating furnace, and other heating furnaces are one of the main consumable equipment in the industry, and each type of blowing ash equipment is used for heating, it is possible to provide effective blast furnace heating efficiency, security design, long cycle high speed operation, and the blowing ash machine is close. One of the most effective blowing ash methods in recent years, including steam blowing ash, air blowing ash, shaking blowing ash, and steel blowing ash, etc., has good blowing ash effectiveness, operation performance is low, equipment is simple, investment is small, etc. After the pottery furnace is processed, the pine-shaped ash can be cleaned and removed, and the hardened ash can be removed, and the temperature of the pottery discharged is low, and the efficiency of the pottery is high, and the long-term consumption of the pottery is low. Highly efficient, safe, efficient, and well-defined.

 

Main features of Shunbuki ashware

1. The ash removal effect is clear, the ash can be used in the evaporator, the smoke prevention force is reduced by the smoke removal temperature, general use is possible, the smoke prevention force is reduced by 100-400Pa, the smoke temperature can be reduced by 5-10℃, the main steam Temperature 5-20°.

 

2. The air force required is 0.6-1.2Mpa, the instantaneous deflagration force of the blowing ash device is 0.6-0.8MPa, and the production capacity is large, so the ash has a large turning bottom, and there is no ash blind spot.

 

3. Ash removal on the line, 1st order per group, 1st order per order, 3-5 "fires", approximately 1-4 minutes.

 

4. It is very convenient to use the air pressure of 0.6-1.2MPa.

 

5. Non-combustible gas for fireworks, overcoming combustible ash blower system excrement leakage or hazardous waste flow in furnace combustion hazards.

 

6. Applicable to the use of high-temperature heaters, internally owned areas with high-temperature heaters, no high-temperature heating furnaces, no impact on the current environment.

 

7. Comprehension of the blowing ash system, one control system, one control system, one control system, one control system, one control system (1.6 MPa), one control system.

 

8. The progress of the book is low, the investment is small, the same amount of money is made, the investment is low, the ash blower is currently in possession, the construction period is fast, the South Taiwan is equipped with one roof, and the installation is convenient.

 

Send Inquiry
Send Inquiry