Based on years of technical research and development, the technical mechanism of the shock wave soot blower incineration device was summarized. The new application of boiler soot blower involves a kind of incineration device, especially a kind of mixed incineration module used in the shock wave soot blowing system. incineration device.
According to the technology in the market, the current incineration tanks of boiler soot blowers generally adopt the method of "blocking" to prevent backfire. If it is necessary to drill small holes or increase the resistance on the upstream pipe to prevent deflagration and backfire, there are also A right-angle tee with a plug is used to connect to the combustion chamber. These technical methods are all about making a fuss about the pipeline to avoid the effect of backfire. This effect is very unsatisfactory during use and is very easy to cause. Blockage of pipes.
Therefore, gravel needs to be filled in the incineration tank to stop the fire, which is better than "blocking" the pipe. However, the boiler soot blower is also very easy to cause blockage in the incineration tank, and the gas in the incineration tank cannot be fully mixed, which is easy to Carbon deposits naturally form in the incineration tank. After working for a long time, the incineration tank will naturally form blockage, causing combustion failure.
The purpose of the new technology is to improve the ignition device, including the air inlet pipe, the ignition tank and the mixed gas acceleration pipe. A flange cover needs to be installed on one end of the air inlet pipe of the equipment, and the other end needs to be connected to the ignition tank, so One end of the mixed gas acceleration tube used is connected to the combustion tank, and the other end needs to be equipped with an outlet flange. The combustion tank needs to be equipped with a turbulent flame arrester.
The air inlet pipe also needs to be equipped with a mixed gas inlet hole, a pressure switch installation hole and a thermal resistor installation hole. The mixed gas acceleration pipe needs to be provided with a spark plug installation hole. Based on the reliability and speed of the new device, simple internal structure, and simple manufacturing, the mixed gas needs to be fully mixed and fluid after entering the incineration tank, and can effectively prevent backfire.
